Search
< Back to Product

Pressure-Pro E4040HGE-HTQB Gas Pressure Washers Reviews & Ratings

Share This Product
Plus 1 This Product
Tweet This Product
Pin It!
Pressure-Pro E4040HGE-HTQB Reviews
Overall Rating
Features
4/5
Quality
4/5
Performance
4/5
Value
3/5
Overall
4.0 out of 54.0 out of 54.0 out of 54.0 out of 54.0 out of 5
Pros
Easy To Store (1)
Reliable (1)
Fast (1)
Easy To Use (1)
Cons
Took Too Long To Recieve (1)
Expensive (1)
Bad Instructions (1)
1 Review  Sort by 
 
Gary M.
Cincinnati, OH
Purchased from Pressure Washers Direct
Purchased 6/2/13
REVIEWED
JUN.
24
2013
4 out of 54 out of 54 out of 54 out of 54 out of 5
Instructions Are A Joke
The instructions are a joke- they don't tell you how to set up for cleaning solutions.

The pressure washer keeps shooting tips out of the end of wand. The tips are placed in properly. Tips are easy to find but you never find the rubber o-ring. I went thru extras that were sent with the unit, but still had to go to the hardware store to buy extras (and yes, I always make sure there is a o-ring in the wand before I put the tip in, and it still blows tips).
Pros: Easy To Use, Fast, Reliable, Easy To Store
Cons: Bad Instructions, Expensive, Took Too Long To Recieve
Gary Does Not Recommend This Product
Brian, the Pressure Washer Expert
Product Expert
Gary,
Page 4 of the Owner's Manual says "Your pressure washer is supplied with a downstream chemical injector. The 1/4" clear vinyl tube is be inserted into the desired chemical to apply. Be sure to use the black, low pressure nozzle to inject chemical. The chemical injector will only open up and allow chemical into the line when this tip is used."

The siphon tube (1/4" clear vinyl tube) functions with the plain end attached to the empty barb on the pump; the end of the tube with the filter on it goes into the soap bucket or bottle.

The soap should be thin, like water; not thick like dish soap.

With respect- most pressure washer quick connect tips do not use an o-ring. Adding an o-ring may be what is causing the tips to blow off under pressure. Please try using the spray tips without an o-ring. If the tips do not seat properly without the o-ring, please give the folks at Pressure-Pro a call directly at (772) 461-4486 in case the spray tip connector is faulty.
more
Was this review helpful?
20
Sign Up
Receive Weekly How-To Tips & Specials