Expert Recommended AccessoriesSelected by Jim, our Expert
Required Accessories9
These accessories are required to properly setup/install this product.
Optional Accessories10
Features
Turn Your Pressure Washer Into A Sewer Jetting Machine
Works with most pressure washers up to 4000 PSI & 4.5 GPM
M407 Spray Gun Attaches Easily
Comes with a 3/8" male quick connect adapter installed
Also comes with an M22 metric threaded male to 3/8" male NPT adapter
Works with M22F & 3/8" F quick connect hoses; teflon tape for tight seals
Expands The Cleaning Capability Of Your Pressure Washer
Unclog, degrease, & clean pipes & drains
Saves time & money over expensive plumber visits
Works Fast
Focused high pressure water breaks apart & flushes tough clogs
Quickly penetrates deep into drains & scrubs away sludge
50 Feet Of 1/4" Flexible Jetter Hose
Twists & turns easily through convoluted piping
1/4" Fixed Spray 4.5 Orifice Jetter Nozzle
Sprays forward for cleaning & backward for flushing debris
Designed For Gas-Powered Pressure Washers
Will not connect to consumer-grade electric units
Be sure to use proper protective gear: gloves. goggles, mask, etc.
Check that your pipes & drains are in good condition before use
California residents see
Warning: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP) which is known to the State of California to cause Developmental Harm, and Diisononyl phthalate (DINP) which is known to the State of California to cause Cancer.
Product QuestionsAnswered by Jim. the Pressure Washer Expert
I purchased an AR 2000 psi electric unit couple of months ago. Great unit. Would like a jetter kit to maintain clean sewer drain lines. Any particular reason these kits are not suggested for electric washers.?? Seems to me 2000 psi would be sufficient to move the lines in & out. Any help is appreciated.
John Russell
from Kansas
August 12, 2016
Answer
If you have the AR390SS the connectors would probably fit- but that wouldn't be the case for most consumer-grade electric pressure washers.
It's not just the water pressure (PSI); it's also the volume of water (gallons-per-minute, or GPM). The AR390SS pushes 1.4 GPM; but most gas units start at 2 GPM and go higher. You need enough pressure to break the clog and enough volume to move the clog backward out of the pipe.
This unit has a maximum rating of 4000 PSI and 4.5 GPM, so its best performance would likely be between about half that (2000 PSI and 2.5 PSI) and just under max (3800 PSI and 4 GPM)
Was this answer helpful?
Yes
1
No
0
What nozzles that come with Jetter Genie and what is the best nozzle to use for residential sewer pipe?
Margaret Mulberry
from Illinois
June 10, 2015
Answer
It comes with what is called a fixed or laser nozzle. This is the best for residential pipes. It will have 1 forward jet to break up the clog and 3 rear facing jets to help the hose advance down the pipe and then continue to break up the clog.