Product QuestionsAnswered by Jim. the Pressure Washer Expert
Question
+−
I have a Craftsman 2700 PSI,2.3 GPM Briggs & Stratton gas powered pressure washer and I want to purchase some extra quick connects and I'm not sure waht to order. I think the connection is 3/8 but I'm not sure.
Don
from Maryland
June 07, 2011
Answer
More than likely this should be a M22 threaded fittings. That is pretty common for units like yours. If that is the case, then the kit you are asking about is more or less what you would need. If you have M22 threaded fittings. More than likely there is going to be some plastic couplers at the end of the hose on each side. If there is, then this would be M22.
Thanks,
Pressure Washers Direct
Was this answer helpful?
Yes
0
No
0
Question
+−
I would like to connect the General Pump High Pressure Soap Shooter Nozzle with Rinse Capability (#4.5) - 100146 to my Sears/Briggs&Stratton power washer with M22 connectors. Can I use the General Pump High-Pressure Hose Quick-Connect Kit - PWD-HOSEQCKIT to make the connections i.e. does the PWD-HOSEQCKIT have 1/4 in QC fittings?
Robert Wills
from Mississippi
May 22, 2011
Answer
If you are looking to connect the high pressure soap shooter. This item would go into the end of the lance on your pressure washer. So this hose QC kit would not work. If your pressure washer is using nozzles, just use the high pressure soap shooter as the nozzle. If you don't have nozzles on the end of your pressure washer lance, then you would need to get a new lance and then you would have this capability.
Thanks,
Pressure Washers Direct
Was this answer helpful?
Yes
0
No
0
Recommended Accessories
Expert Recommended AccessoriesSelected by Jim, our Expert
Required Accessories9
These accessories are required to properly setup/install this product.
Optional Accessories10
How-To Articles
How To Pick The Perfect Replacement Power Washer Gun
Even with the best intentions, stuff happens: the spray gun that went into the ...